HW 5 Problem 2 Address Trace Table

Print this table and fill in the values by hand and turn it in with your submission. Run each trace using mem_system_perfbench. Determine when the events listed in the table occur and write down the cycle number. This should be an in integer and should be the DUT/clkgen/cycle_count signal. This is NOT the raw simulation time that vsim shows you.

The first row is filled up as 3 because I am assuming your cache can accept a request in the cycle immediately after reset, which is cycle 3 in our testbench.

Copy from here: /u/k/a/karu/courses/cs552/spring2013/handouts/verilog_code/hw5-mem/test_traces

Description of traces

Event	Cycle count
mem_2way1.addr
ld (0 1 348 0) (arrives in mem_system)	3
Reply back to processor (Done == 1)
mem_2way2.addr
Third ld (0 1 348 0)
Reply back to processor (Done == 1)
mem_2way3.addr
st (1 0 348 56) (arrives in mem_system)
Reply back to processor (Done == 1)
mem_2way4.addr
Third st (1 0 348 23) (arrives in mem_system)
Reply back to processor (Done == 1)
mem_2way5.addr
Third ld (0 1 4444 0) (arrives in mem_system)
Reply back to processor (Done == 1)
mem_2way6.addr
Third st (1 0 4444 61) (arrives in mem_system)
Reply back to processor (Done == 1)